Drive Shaft - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 06 DRIVE SYSTEM
Subsection 02 (MIDDLE AND REAR FINAL DRIVE)
TIGHTENING TORQUE
Wheel hub nut
NOTE: If required, tighten castellated nut further
to align grooves with drive shaft hole.
Install a NEW cotter pin.
tmr2011-032-005

DRIVE SHAFT

Drive Shaft Removal
vmr2015-139-001
Remove the wheel hub. See procedure in this
subsection.
Drain oil from applicable differential. Refer to
RIODIC MAINTENANCE PROCEDURES
tion.
Remove trailing arm. Refer to
SION
subsection.
Strongly pull drive shaft out of differential.
482
205 N•m ± 15 N•m
(151 lbf•ft ± 11 lbf•ft)
PE-
subsec-
REAR SUSPEN-
Drive Shaft Inspection
Inspect the condition of boots. If there is any dam-
age or evidence of leaking lubricant, replace them.
Refer to DRIVE SHAFT BOOT
Check shaft splines. Replace drive shaft if neces-
sary.
Check dust shield on drive shaft end. Replace if
necessary.
Drive Shaft Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following:
Install a NEW stop ring.
V07H0AA
TYPICAL
1. NEW stop ring
After drive shaft insertion in rear final drive, vali-
date if properly locked.
Refill rear final drive. Refer to
NANCE PROCEDURES
DRIVE SHAFT BOOT
Drive Shaft Boot Removal
Remove the drive shaft from vehicle. See proce-
dure in this subsection.
Remove drive shaft boot clamps using the follow-
ing tool:
TOOL
CV BOOT CLAMP PLIER
(P/N 529 036 120)
Dislodge the large boot end.
Separate the joint from the shaft. Two procedures
can be done.
Without the Special Tool
Clamp joint housing in a vise.
Align shaft with joint.
Pull hard on shaft to remove from joint.
.
1
PERIODIC MAINTE-
subsection.
vmr2015-139