BRP Cam-am Outlander 6x6 DPS 2015 Manual page 230

Section 03 ELECTRONIC MANAGEMENT SYSTEMS
Subsection 04 (DIAGNOSTIC SYSTEM AND FAULT CODES)
lmr2010-019-001
TYPICAL - MODULE SUBMENU LIST
6. Refer to the following table to find the appropri-
ate subsection in this manual to diagnose the
missing module.
MISSING
SECTION TO REFER TO
MODULE
ECM ELECTRONIC FUEL INJECTION (EFI)
Cluster LIGHTS, GAUGE AND ACCESSORIES
STEERING (DPS) AND FRONT
DPS
Diagnostic Tips
To see the last minute of operating conditions,
click on the History tab in B.U.D.S.
NOTE: The page displays data whatever there is
fault code(s) or not.
rmr2011-070-003_a
1. History tab
2. Additional history pages
364
WHEELS
HISTORY PAGE DESCRIPTION
ITEM
Display the minimum and maximum
Minimum/
values encountered. Click "Clear
Maximum
Min/Max" to reset the values
Display the time proportion in what
Run time
mode the engine was running in
RPM Display the RPM range proportion in
profile which the engine was running in
When a minor fault occurs:
– Turn ignition key OFF.
– Wait 30 seconds.
– Turn ignition key ON.
This should change the fault state from "Active" to
"Occurred".
The vehicle should then operate normally.
If a sensor-related fault persists, you may try
disconnecting/reconnecting the sensor.
Read the following for a general approach to trou-
bleshoot fault codes (active or occurred).
INFORMATION
vmr2015-128