BRP Cam-am Outlander 6x6 DPS 2015 Manual page 180

Section 02 ENGINE, CVT AND GEARBOX
Subsection 15 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT) (650))
REQUIRED TOOL
Dial bore gauge
MEASURING POINT
At least 5 mm (1/4 in) from bushing edge
BUSHING INNER DIAMETER
NEW
SERVICE LIMIT
Fixed Sheave
Check fixed sheave for cracks and excessive
wear. Replace fixed sheave if necessary.
Check ball bearing for free play and smooth oper-
ation. Replace if necessary.
Check shaft for heavy wear or visible damage. Re-
place if necessary.
If the shaft is removed, measure bushing inner di-
ameter.
NOTE: This bushing cannot be replaced. Replace
fixed sheave if bushing is out of specification. Vi-
sually inspect coatings.
tmr2011-015-010_a
1. Bushing
2. Fixed sheave of driven pulley
REQUIRED TOOL
Dial bore gauge
MEASURING POINT
At least 5 mm (1/4 in) from bushing edge
288
30.060 mm to 30.100 mm
(1.183 in to 1.185 in)
30.200 mm (1.189 in)
BUSHING INNER DIAMETER
NEW
SERVICE LIMIT
Check torque gear for visible damage and cracks.
Measure for wear limit using a caliper.
tmr2011-015-011_a
A. Measurement inside
B. Measurement outside
WEAR ON TEETH (BOTH SIDES)
SERVICE LIMIT
Cam
Check cam for visible damage and measure for
wear using a caliper.
vmr2015-121-003_a
1. Caliper
2. Contact surface
A. Width to be measured due to wear on contact surface
WIDTH ON TOP SURFACE
SERVICE LIMIT
30.060 mm to 30.100 mm
(1.183 in to 1.185 in)
30.200 mm (1.189 in)
7.500 mm (.295 in)
4.50 mm (.177 in)
vmr2015-121