BRP Cam-am Outlander 6x6 DPS 2015 Manual page 190

GBPS Signal Wire Continuity Test
Unplug ECM connector and connect it to the
adapter tool.
REQUIRED TOOL
ECM ADAPTER TOOL (P/N 529 036 166)
MULTIMETER PROBE
POSITIONS
GBPS connector (pin 2)
and ECM adapter tool (pin D2)
If resistance is out of specification, check wires
and connectors. Repair and reset fault codes.
If resistance is good and the other tests suc-
ceeded, replace the GBPS and reset fault codes.
NOTE: The GBPS must be reset.
GBPS Removal
Set shift lever in NEUTRAL position.
Unplug GBPS connector.
Remove screws and withdraw GBPS.
Tmr2011-016-010_a
1. Screws
2. Gearbox Position Sensor (GBPS)
GBPS Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
Shift lever must be in the NEUTRAL position.
Align GBPS with the flat on the shift drum shaft.
vmr2015-123
Section 02 ENGINE, CVT AND GEARBOX
Subsection 17 (GEARBOX AND COUPLING UNIT)
IMPORTANT: Do not force to install GBPS if shaft
flat is not properly aligned. If alignment is incor-
rect, check shift rod adjustment.
RESISTANCE
@ 20°C (68°F)
Below 1
Tmr2011-016-011_a
1. Flat on shift drum shaft
Reset the GBPS. Refer to
subsection.
4WD INDICATOR SWITCH
4WD Indicator Switch Access
To reach the 4WD indicator switch, refer to
and remove the following parts:
– Seat
– Console
– RH side panel.
4WD Indicator Switch Removal
Disconnect 4WD indicator switch connector.
Tmr2011-016-012_a
1. 4 WD indicator switch
2. Actuator
4WD Indicator Switch Test
Measure switch resistance as follows.
GBPS RESET
in this
BODY
321