Engine Removal - BRP Cam-am Outlander 6x6 DPS 2015 Manual

GENERAL
The engine drive shaft transmits the power from
the gearbox to the front differential and is located
inside the crankcase.
IMPORTANT: Note position of parts on disas-
sembly. This may help to find the root cause of
a problem. A component that is not replaced
should be reinstalled in the same position as
originally mounted.
PROCEDURES
ENGINE DRIVE SHAFT
Engine Drive Shaft Removal
Remove the engine. Refer to
AND INSTALLATION
subsection.
Rear Bearing Cover Removal
Detach gearbox from engine, refer to
AND COUPLING UNIT
At rear of engine, remove the bearing cover and
its O-ring.
tmr2011-014-006_a
1. Bearing cover screws
2. O-ring
3. Bearing cover gearbox side
Front Bearing Cover Removal
Remove the bearing cover at the front of the en-
gine.
NOTICE
Check ends of the circlip for sharp
edges or burrs before removing the drive shaft,
to avoid damaging the oil seal.
vmr2015-120

ENGINE REMOVAL

GEARBOX
subsection.
Section 02 ENGINE, CVT AND GEARBOX
Subsection 13 (BOTTOM END (650))
tmr2011-014-007_a
1. Bearing cover front drive side
2. Circlip
3. Drive shaft
Engine Drive Shaft Removal
Split crankcase, refer to
section.
Remove engine drive shaft from the crankcase.
tmr2011-014-008_a
1. Crankcase MAG side
2. Engine drive shaft
Engine Drive Shaft Inspection
Replace oil seals and/or O-ring (bearing cover
gearbox side) if they are brittle, hard or damaged.
Check drive shaft bearings for contamination
and/or metal shavings. Check if bearings turn
freely and smoothly. Replace if necessary.
CRANKCASE
in this sub-
229