Tightening Torque - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2012-039-035_a
1. DPS heat shield
2. Retaining screws to hold steady (2 not visible)
3. Retaining nuts to remove
DPS Unit Installation
IMPORTANT: The following hardware must all
be replaced with new ones:
– Hexagonal forming screws with threadlocker
– Conical spring washers
– Elastic nuts.
1. If the DPS unit is being replaced, install heat
shield from old DPS unit onto new DPS unit.
vmr2012-039-035_a
1. DPS heat shield
2. Retaining screws to hold steady (2 not visible)
3. Retaining nuts to remove (2)
NOTE: Important: Hold DPS housing screws
steady using a wrench as you apply specified
torque to heat shield retaining nuts.

TIGHTENING TORQUE

Retaining nuts, DPS
heat shield
2. Install LH DPS support bracket loosely using
NEW fasteners.
vmr2015-142
Subsection 03 (DYNAMIC POWER STEERING (DPS))
24.5 N•m ± 3.5 N•m
(18 lbf•ft ± 3 lbf•ft)
Section 07 CHASSIS
NOTE: Important: Install the retaining screws to
the DPS support bracket loosely at this time. This
is required to ensure proper DPS alignment at a
later step when all steering and DPS fasteners are
tightened to specified torque.
vmr2012-039-034_a
1. LH DPS support bracket
2. Retaining screws
3. Ensure "O" rings on steering shaft are in good
condition.
4. Apply
XPS SYNTHETIC GREASE (P/N 293 550 010)
to:
– The inside of both steering shaft half bush-
ings
– The steering shaft and "O" rings.
vmr2012-039-017_a
A. XPS synthetic grease (P/N 293 550 010) here
527