BRP Cam-am Outlander 6x6 DPS 2015 Manual page 408

mmr2009-023-027_e
1. MIN function selected
7. Turn the handlebar momentarily against the
steering frame stops to each side.
NOTE: Do not hold steering against frame stops
for an extended period of time.
8. Read the MIN charging system voltage
recorded while the handlebar was turned
against each stop.
DPS SYSTEM LOAD TEST
PROBE POSITIONS
Battery (-) DPS fuse
terminal holder pin B
NOTE: Turning the
against the frame stops generates maximum
DPS load (maximum current draw on electrical
system). Electrical system must sustain at least
12 Vdc for proper DPS operation.
vmr2015-142
Subsection 03 (DYNAMIC POWER STEERING (DPS))
STEERING VOLTAGE
POSITION READING
LH stop
At least
12 Vdc
RH stop
handlebar momentarily
Section 07 CHASSIS
vmr2010-003-007
If the electrical system cannot sustain at least
12 Vdc, check the following:
– Battery
– Battery connections
– DPS unit power and ground connections
– Charging system
– Frame and engine ground studs.
If the previously listed items, carry out the follow-
ing DPS UNIT CURRENT TEST
DPS Unit Current Test
1. Connect vehicle to the latest applicable
B.U.D.S. software version.
2. Click on the Read Data button.
3. Choose the Monitoring page tab.
4. At the bottom of the Monitoring page, choose
the DPS tab.
vmr2010-003-008_a
Step 1: Press Data button
Step 2: Select Monitoring page tab
Step 3: Select DPS tab
.
523