BRP Cam-am Outlander 6x6 DPS 2015 Manual page 411

Section 07 CHASSIS
Subsection 03 (DYNAMIC POWER STEERING (DPS))
vmr2012-039-014_a
DPS REMOVAL - RH SIDE
1. DPS
2. RH DPS support bracket
3. Remove these screws (2)
NOTE: Discard the conical spring washers on the
DPS retaining screws.
12. On the LH side of the DPS unit, remove the
DPS support bracket from the frame in the fol-
lowing manner:
12.1 Remove the top retaining screw.
12.2 Loosen the lower retaining screw suffi-
ciently for the bracket to become loose
on the frame.
vmr2012-039-015_a
DPS REMOVAL - LEFT SIDE
Step 1: Remove DPS retaining screws (2 each side)
Step 2: Discard conical washers under screw head
13. Pull up on DPS unit to remove the DPS unit
and support bracket from the frame.
526
vmr2012-039-016_a
TYPICAL - LH DPS SUPPORT BRACKET
1. DPS unit
2. DPS support bracket
3. Vehicle frame
4. Slotted hole in DPS support bracket
14. If replacing DPS unit, remove the following
from the DPS unit:
– LH DPS support bracket
– DPS heat shield.
vmr2012-039-034_a
1. LH DPS support bracket
2. Retaining screws
NOTE: When removing the DPS heat shield, hold
the DPS housing screws steady using a wrench
to as you remove the 2 heat shield retaining nuts.
vmr2015-142