Starter Drive Gears - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Check needle bearing condition. Replace sprag
clutch gear if necessary.
vmr2006-041-016_a
INSPECT
1. Teeth
2. Collar
3. Needle bearing
Sprag Clutch Gear Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
NOTE: Apply engine oil on needle bearing and col-
lar of sprag clutch gear.

STARTER DRIVE GEARS

Starter Drive Gear Location
The starter drive gears are located on the engine
MAG side behind the magneto cover.
Starter Drive Gear Removal
Remove MAGNETO COVER
this subsection.
Remove location pins, starter double gear and in-
termediate gear.
vmr2015-116
Section 02 ENGINE, CVT AND GEARBOX
. See procedure in
Subsection 07 (MAGNETO AND STARTER)
vmr2006-041-017_a
1. Intermediate gear
2. Starter double gear
3. Starter gear
4. Location pins
Starter Drive Gear Inspection
Inspect gears and location pins for wear and dam-
age.
Replace parts as necessary.
Starter Drive Gear Installation
The installation is the reverse of the removal pro-
cedure. Pay attention to the following details.
Apply
LOCTITE 767
on starter gear before installing
(P/N 293 800 070)
the starter double gear.
Apply engine oil on location pins.
(ANTISEIZE LUBRICANT)
147