Shift Rod - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2012-021-005_a
SHIFT LEVER HANDLE ALIGNMENT
1. Handle
2. Ridge
A. Handle parallel with ridge
Check if shift lever works properly in all positions.
– Shift lever must be perfectly centered with the
neutral mark when transmission is engaged in
neutral.
– If adjustment is required, refer to
ADJUSTMENT in this subsection.

SHIFT ROD

Shift Rod Adjustment
1. Place shift lever in NEUTRAL position.
NOTICE
Move vehicle back and forth to en-
sure gearbox is set in neutral position.
2. Secure vehicle using wheel blocks.
3. Remove body parts as required. Refer to
LEVER ACCESS
in this subsection.
4. Loosen shift rod adjustment nuts.
vmr2012-021-007_a
TYPICAL — SOME PARTS REMOVED FOR CLARITY
1. Adjustment nuts
vmr2015-124
Section 02 ENGINE, CVT AND GEARBOX
5. Turn rod adjuster to center shift lever in neutral
notch.
– Ensure there is the same threaded length
each side of rod adjuster.
– Be aware that a nut has LH threads.
SHIFT ROD
vmr2012-021-006_a
SHIFT LEVER CENTERED WITHIN NEUTRAL NOTCH
A. Shift lever
B. Neutral notch
6. Move shift lever in R position then in H position.
7. Place shift lever in NEUTRAL position.
8. Check if shift lever is properly centered in neu-
tral notch. Readjust as required.
9. Test the shifter to confirm that the system
works properly in all positions.
NOTE: Make sure the ball joint is properly aligned
SHIFT
with the shift plate. It may be necessary to realign
shift rod ball joints to allow easy movement.
After adjustment, make sure that PARK posi-
tion works properly.
SHIFT PLATE
Shift Plate Removal
Do not remove shift plate needlessly.
1. Refer to
lowing components:
– Seat
– Console
– RH side panel
– RH footrest panel.
2. Remove shift rod from shift plate.
Subsection 18 (SHIFTER)
WARNING
BODY
subsection and remove the fol-
343