BRP Cam-am Outlander 6x6 DPS 2015 Manual page 72

Section 02 ENGINE, CVT AND GEARBOX
Subsection 04 (LUBRICATION SYSTEM)
vmr2006-042-009_a
1. Oil pump
Oil Pump Removal
Remove the PTO cover. Refer to
BOTTOM END
the subsection.
1. Remove:
– Retaining ring
– Oil pump gear
– Needle pin
– Thrust washer.
tmr2011-010-011_a
1. Thrust washer
2. Needle pin
3. Oil pump gear
4. Retaining ring
2. Remove oil pump cover screws and pull oil
pump cover out.
94
vmr2006-042-011_a
1. Retaining screws
2. Oil pump cover
3. Remove oil pump shaft with needle pin and in-
ner rotor.
4. Remove outer rotor.
PTO COVER
in
tmr2011-010-012_a
1. Outer rotor
2. Needle pin
3. Oil pump shaft
4. Inner rotor
Oil Pump Inspection
Inspect oil pump and oil pump cover bore for
marks, scratches or other damages. Check for
scratches in crankcase between outer rotor and
oil pump bore. If so, replace damaged parts.
Check oil pump cover for damages and for surface
straightness with a straightedge.
vmr2015-114