Crankshaft Position Sensor (Cps) - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 04 FUEL SYSTEM
Subsection 01 (ELECTRONIC FUEL INJECTION (EFI))
Clean all remaining parts and install the idle air
control valve on the throttle body.
Proceed with the Closed Throttle and Idle Ac-
tuator Reset. See procedure in
TLE AN D IDLE ACTUATOR RESET
tion.
CRANKSHAFT POSITION
SENSOR (CPS)
ENGINE MANAGEMENT SYSTEM
Refer to the
subsection for component and connector loca-
tions.
NOTE: Take into account that a CPS fault can be
triggered by bent or missing encoder wheel teeth.
First check fault codes using B.U.D.S., then check
the encoder wheel teeth condition if necessary.
Refer to MAGNETO AND STARTER
CPS Access
Remove the RH side panel. Refer to
section.
To reach the CPS connector, remove protector
from engine.
vmr2015-129-003
CPS Resistance Test
Disconnect the ECM connector.
Install the ECM adapter on the ECM connector.
Using a multimeter, measure resistance as per fol-
lowing table.
ECM ADAPTER
PIN
D1 E1
384
CLOSED THROT-
in this subsec-
subsection.
BODY
sub-
MEASUREMENT
RESISTANCE
@ 20°C (68°F)
700 - 900
If resistance value is incorrect, check or repair the
connectors and the wiring harness between ECM
connector and the CPS. If resistance value is still
incorrect, replace CPS.
CPS Replacement
CPS ACCESS
Refer to in this subsection to reach
CPS.
Disconnect CPS connector and cut harness lock-
ing tie (if applicable).
Remove CPS retaining screw and pull up on CPS
to remove it.
vmr2015-129-004
Install new CPS and secure harness with a new
locking tie (as applicable).
CPS INSTALLATION
O-RING
XPS SYNTHETIC GREASE
TIGHTENING TORQUE
SENSOR
SCREW
PRODUCT
(P/N 293 550 010)
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
vmr2015-129