BRP Cam-am Outlander 6x6 DPS 2015 Manual page 296

Section 04 FUEL SYSTEM
Subsection 02 (FUEL TANK AND FUEL PUMP)
FUEL LEVEL SENDER RESISTANCE TEST
GAUGE
FUEL LEVEL
CONNECTOR
Full
Pins 4 and 21
Empty
vmr2006-020-052_c
If readings are out of specification, refer to
LEVEL SENDER RESISTANCE TEST (AT FUEL
PUMP CONNECTOR)
.
If readings are as specified, refer to
SENDER INPUT VOLTAGE TEST
Fuel Level Sender Resistance Test
(at Fuel Pump Connector)
FUEL LEVEL SENDER RESISTANCE TEST
FUEL PUMP
FUEL LEVEL
CONNECTOR
Full
Pins 1 and 2
Empty
If resistance test at fuel pump connector is failed,
replace fuel pump module.
Fuel Level Sender Input Voltage Test
1. Set ignition switch to ON.
2. Disconnect fuel pump connector, refer to
PUMP CONNECTOR ACCESS
tion.
3. Measure for input voltage as follows.
404
RESISTANCE
@ 20°C (68°F)
5 ± 1
100 ± 5
5V is not read
Wiring continuity is good
Wiring continuity is not
obtained
Fuel Level Sender Replacement
Replace fuel pump. Refer to
subsection.
FUEL TANK VENT VALVES
Fuel Tank Vent Valve Test
Inlet Check Valve Test
1. Remove rear body module, refer to
FUEL
2. Remove multifunction gauge for access to
FUEL LEVEL
3. Install a small hose pincher between the vent
.
RESISTANCE
@ 20°C (68°F)
5 ± 1
100 ± 5
FUEL
in this subsec-
FUEL LEVEL SENDER INPUT VOLTAGE TEST
FUEL PUMP
BATTERY
CONNECTOR
Negative
Pin 2
terminal
TEST RESULT
section.
the vent system inlet hose, refer to the
LIGHTS/GAUGE/ACCESSORIES
pressure relief valve and the fuel pump vent in-
let.
REQUIRED TOOL
SMALL HOSE PINCHER
(P/N 295 000 076)
VOLTAGE
5V
SERVICE ACTION
Test wiring continuity
between fuel level
sender and multifunction
gauge
Replace multifunction
gauge
Repair or replace wiring
FUEL PUMP
in this
BODY
sub-
subsection.
vmr2015-130