Fuel Pump - BRP Cam-am Outlander 6x6 DPS 2015 Manual

TIGHTENING TORQUE
Fuel tank retaining
screws
Be sure to properly connect and route:
– Fuel tank vent tube
– Fuel pump pressure hose
– Electrical connectors.
Refuel tank and ensure there are no leaks by
FUEL TANK LEAK TEST
performing a
PUMP PRESSURE TEST
section.

FUEL PUMP

Fuel Pressure Release
Remove fuel pump relay fuse (F15), refer to
POWER DISTRIBUTION
Start and run engine until it runs out of fuel.
Fuel Pump Pressure Test
INSPECTION
Refer to in this subsection.
Fuel Pump Quick Test
1. Turn ignition key to ON.
2. Listen for fuel pump operation.
NOTE: Fuel pump should come ON for a few sec-
onds, then stop.
If fuel pump does not come ON, carry out the fol-
lowing:
– Check fuel pump relay fuse (F15).
– Check in B.U.D.S. for applicable fault codes.
COMMUNICATION TOOLS AND
Refer to
B.U.D.S.
subsection.
– Carry out a fuel pump input voltage test.
vmr2012-028-006_b
1. Fuel pump relay fuse
vmr2015-130
6.5 N•m ± 0.5 N•m
(58 lbf•in ± 4 lbf•in)
FUEL
and a
as described in this sub-
subsection.
Section 04 FUEL SYSTEM
Subsection 02 (FUEL TANK AND FUEL PUMP)
Fuel Pump Connector Access
The fuel pump connector can be accessed from
under the RH rear fender, just above the forward
end of the fuel tank.
vmr2012-028-025_a
TYPICAL
1. Fuel pump connector
2. Fuel tank
3. Underside of RH rear fender
Fuel Pump Input Voltage Test
1. Disconnect the fuel pump connector.
2. Turn ignition key ON.
3. Read voltage as follows.
REQUIRED TOOLS
FLUKE 115 MULTIMETER
(P/N 529 035 868)
FLUKE RIGID BACK PROBE
(P/N TP88)
FUEL PUMP INPUT VOLTAGE TEST
TEST PROBES
Fuel pump
connector
Pin 3
If battery voltage is read, carry out a fuel pump
resistance test.
If battery voltage is not read, test fuel pump
power input as follows.
VOLTAGE
READING
Fuel pump
connector Battery voltage
Pin 4
399