Engine Oil Filter - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 01 MAINTENANCE
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
vmr2015-107-004_a
1. Drain plug
NOTE: Allow oil to drain completely from the
crankcase.
8. Clean the magnetic drain plug from metal shav-
ings and residue. Presence of debris gives an
indication of internal engine damage.
9. Install a NEW gasket ring on the drain plug.
NOTICE
Never use the gasket ring a second
time. Always replace by a new one.
10. Install and tighten drain plug to the recom-
mended torque.
DRAIN PLUG
Tightening torque
11. Replace oil filter. Refer to
REPLACEMENT
in this subsection.
12. Refill engine with recommended engine oil.
ENGINE OIL CAPACITY
2 L (2.1 qt (U.S. liq.))
13. After filling, check the oil level, refer to
GINE OIL LEVEL VERIFICATION
section.
14. Start engine and let it idle for a few minutes.
15. Ensure oil filter and drain plug areas are not
leaking.
16. Stop engine.
17. Wait a while to allow oil to flow down to
crankcase, then check oil level again.
18. Dispose oil and filter as per your local environ-
mental regulations.
18
30 N•m ± 2 N•m
(22 lbf•ft ± 1 lbf•ft)

ENGINE OIL FILTER

EN-
in this sub-
Engine Oil Filter Replacement
Engine Oil Filter Access
To reach oil filter, refer to
remove the following parts:
– Seat
– Console
– RH side panel
– RH footrest panel.
Engine Oil Filter Removal
1. Clean oil filter area.
2. Remove oil filter cover screws.
3. Remove oil filter cover.
4. Remove oil filter.
vmr2015-063-002_a
1. Oil filter cover screw
2. Oil filter cover
3. O-ring
4. Oil filter
Engine Oil Filter Installation
1. Check and clean the oil filter inlet and outlet
area of dirt and other contaminations.
vmr2015-063-003_a
1. Outlet bore to the engine oil providing system
2. Inlet bore from the oil pump to the oil filter
BODY subsection and
vmr2015-107