BRP Cam-am Outlander 6x6 DPS 2015 Manual page 88

REQUIRED TOOLS
ROTARY SEAL PUSHER PLATE (P/N 529 036 130)
4x M6 x 85 screws (P/N 420 440 347)
4x tubes 70 mm (2.75 in)
SEAL PUSHER (P/N 529 035 766)
529036130
ROTARY SEAL PUSHER PLATE (P/N 529 036 130)
529035766
SEAL PUSHER (P/N 529 035 766)
tmr2011-011-058_a
ROTARY SEAL PUSHER PLATE ASSEMBLY
1. 4 x tubes (70 mm (2.75 in) length)
2. 4 x screws M6 x 85
3. Plane surface on pusher bolt
vmr2015-114
Section 02 ENGINE, CVT AND GEARBOX
Subsection 05 (COOLING SYSTEM (650))
12. Install rotary
crankcase as follows.
NOTE: Make sure pusher bolt has a plane
surface.
12.1 Apply a little grease at the end of tool
pusher bolt.
12.2 Ensure that pusher bolt is completely un-
screwed.
12.3 Install rotary seal pusher plate on
crankcase by tightening M6 screws.
NOTICE
Do not use pneumatic or elec-
tric tools for tightening screws.
tmr2011-011-059_a
ROTARY SEAL PUSHER PLATE INSTALLATION
1. Rotary seal pusher plate
2. Tube (70 mm (2.75 in) length)
3. M6 x 85 screw
4. Pusher bolt
12.4 Install seal pusher between rotary seal
pusher plate and water pump shaft.
tmr2011-011-060_a
SEAL PUSHER INSTALLATION
1. Seal pusher aligned with pusher bolt
12.5 Tighten the pusher bolt by hand until it
stops against the seal pusher.
13. Carefully thread the pusher bolt 1-1/2 turns.
seal installation tools on
111