Maintenance Procedures; Pressure Relief Valve - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2015-130-002_d

1. Pressure relief valve

2. Fuel pump vent inlet
3. Install small hose pincher here
4. Connect the vacuum/pressure pump to the fuel
tank vent hose inlet.
REQUIRED TOOL
VACUUM/PRESSURE PUMP
(P/N 529 021 800)
vmr2012-028-008_a
1. Fuel tank vent hose inlet
2. Gauge connector
5. Remove fuel tank cap.
6. Set vacuum/pressure pump to PRESSURE and
activate pump. The gauge on the pump should
not change in reading.
7. Set vacuum/pressure pump to VACUUM and
activate pump. The gauge should increase in
reading.
If the test failed, carry out the following:
– Ensure breather filter is properly installed, refer
PERIODIC MAINTENANCE PROCEDURES
to
vmr2015-130
Section 04 FUEL SYSTEM
Subsection 02 (FUEL TANK AND FUEL PUMP)
– Ensure inlet check valve is properly installed, re-
FUEL TANK VENT VALVE INSTALLATION
fer to
in this subsection.
– Test inlet check valve separately. If good, re-
place the breather filter, refer to

MAINTENANCE PROCEDURES

Pressure Relief Valve Test
1. Install the small hose pincher between the inlet
check valve and the fuel pump vent inlet fitting.
vmr2015-130-002_e
1. Inlet check valve
2. Fuel pump vent inlet fitting
3. Install small hose pincher here
2. Set vacuum/pressure pump to PRESSURE and
activate pump. The gauge should increase in
reading.
3. Set vacuum/pressure pump to VACUUM and
activate pump. The gauge on the pump should
not change in reading.
If the test failed, carry out the following:
– Ensure pressure relief valve is properly in-
stalled, refer to
INSTALLATION
– Replace pressure relief valve if it fails the test.
.
PERIODIC
.
PRESSURE RELIEF VALVE
in this subsection.
405