BRP Cam-am Outlander 6x6 DPS 2015 Manual page 192

Tmr2011-016-025_a
1. Actuator
2. Washer
3. Screw
Pull the actuator out of housing.
Actuator Installation
Lubricate actuator O-ring.
ACTUATOR O-RING
Service product
Vmr2015-123-003_a
1. Actuator O-ring
Ensure coupling fork is in 4WD position (posi-
tioned toward the front of vehicle).
vmr2015-123
Section 02 ENGINE, CVT AND GEARBOX
Subsection 17 (GEARBOX AND COUPLING UNIT)
SUPER LUBE GREASE
(P/N 293 550 030)
Tmr2011-016-026_a
1. Coupling fork in 4WD position
Align the actuator fork with the pin on coupling
fork then push the actuator in the housing. See
the following illustration to position the actuator
correctly.
Tmr2011-016-027_a
1. Actuator
2. Actuator fork
3. Coupling fork
Rotate the actuator counterclockwise until it ori-
ents itself to mounting position.
NOTICE
Do not cut or break the actuator
O-ring.
Install all actuator screws and tighten them.
ACTUATOR SCREWS
Tightening torque
Connect actuator.
Lift the front of vehicle.
Turn front wheels. The front propeller shaft
should not turn (the PARK position must be se-
lected).
25 N•m ± 3 N•m
(18 lbf•ft ± 2 lbf•ft)
323