Drive Gears - BRP Cam-am Outlander 6x6 DPS 2015 Manual

vmr2006-044-008_a
1. Mark position of oil bore on PTO cover
2. Mark position of oil bore on plain bearing remover/installer
NOTICE
Misalignment of plain bearing and
PTO cover oil bores will prevent proper oil
supply to plain bearings.
3. Carefully press in the plain bearings in the same
direction as during disassembly, from the out-
side towards the inside.
NOTE: Support PTO cover using a suitable sup-
port with a straight surface to prevent damage of
the sealing surface.
NOTICE
The joining surfaces of the plain
bearings must be positioned near the oil bore
in a counterclockwise direction.
tmr2011-014-013_c
1. Plain bearing joint
2. PTO cover (inside surface)
3. Oil bore
PTO Cover Installation
For installation, reverse the removal procedure
however, pay attention to the following details.
NOTE: At installation, replace PTO cover gasket
and oil seal.
vmr2015-120
Section 02 ENGINE, CVT AND GEARBOX
Subsection 13 (BOTTOM END (650))
Tighten PTO cover screws following the sequence
illustrated.
vmr2006-044-003_b
TIGHTENING SEQUENCE
PTO COVER SCREWS
Tightening torque

DRIVE GEARS

Drive Gears Location
The engine is equipped with a breather gear which
prevents engine oil from seeping out through the
breathing system into the air intake system.
The drive gears are located on the engine PTO
side behind the PTO cover.
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
235