Engine Oil - BRP can-am COMMANDER 2017 Series Operator's Manual

tmo2013-003-050_a
1. CVT air filter
2. Clean filter, using soft soap and wa-
ter, then water rinse.
3. Gently shake off excess water and
allow filter to dry at room tempera-
ture.
4. Clean inside the CVT air inlet with a
vacuum cleaner.
tbs2011-009-006_a
1. CVT air inlet
CVT Air Filter Installation
Reinstall CVT air filter and cover.
NOTE: Maintaining a clean CVT air
filter will maximize air flow for an opti-
mum CVT components lifespan.

Engine Oil

Engine Oil Level Verification
NOTICE
Operating
with an improper level may severely
damage engine.
NOTE: Dipstick is located under pas-
senger seat.
the engine
_______________
MAINTENANCE PROCEDURES
With vehicle on a level surface and en-
gine cold, check the oil level as follows:
1. Unscrew dipstick then remove it
and wipe clean.
tmo2011-001-075_a
1. Dipstick
2. Reinstall dipstick, screw in it com-
pletely.
3. Remove dipstick and check oil level.
It should be near or equal to the up-
per mark.
tmo2011-001-076_a
TYPICAL
1. MIN
2. MAX
3. Operating range
To add oil, remove the dipstick. Place a
funnel into the dipstick tube.
Add a small amount of recommended
oil and recheck oil level.
Repeat the above procedures until
oil level reaches the dipstick's upper
mark.
NOTE: Do not overfill. Wipe off any
spillage.
Properly tighten dipstick.
95