BRP Cam-am Outlander 6x6 DPS 2015 Manual page 474

Heating Control Module Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Install new locking ties.
Gently tighten retaining screw to a snug fit.
NOTICE
Do not over tighten as it may cause
the heating control module to crack.
vmr2015-147-003_a
A. 0°
Heated Throttle Lever Removal
1. Remove the console. Refer to
tion.
2. Remove the handlebar cover. Refer to
ING SYSTEM
subsection.
3. Remove the gauge support. Refer to
GAUGE AND ACCESSORIES
4. Disconnect the heated throttle lever connector
(orange wire) located under the air intake duct.
vmr2015-147-002
5. Cut RH side and center locking ties.
vmr2015-147
vmr2015-147-001_b
6. Gently pull the heated throttle lever harness out
7. Remove and keep the 3 retaining screws under
BODY
subsec-
STEER-
LIGHTS,
subsection.
vmr2015-147-004
8. Separate housing.
9. Remove and keep inner housing protector.
Section 07 CHASSIS
Subsection 08 (OPTION PACKAGES)
of the console support.
the throttle lever.
593