BRP Cam-am Outlander 6x6 DPS 2015 Manual page 478

NOTE: The grips are quite hard to push over so be
prepared to apply a considerable amount of force
to install them. It is recommended to turn the han-
dlebars completely to the left or right and to firmly
secure them so that they do not move when the
grips are installed. The resistance increases the
further the grips are pushed in so be prepared to
push and twist the grips to finish the installation.
NOTICE
Do not use a tool or hammer to in-
stall the grips as this will damage the heater.
NOTE: If the grip gets stuck halfway through,
connect the grip and make it heat. Refer to Heat-
ing control module installation step 7 to 10 for
instructions. You will need to connect the red
wire of the grip to the red wire of the heating
control module. Then, plug the 12 V power con-
nector to the one on the vehicle. Once wires
are connected, put the key to ON position, use
controls and set 4th heating level.
6. Repeat steps 4 to 7 for the RH side grip.
7. Install handlebar caps and tighten to specifica-
tion.
vsi2012-009-022
TIGHTENING TORQUE
Handlebar cap retaining
screw
8. Route wires and plug connectors.
9. Install new locking ties.
10. Install gauge support, console and handlebar
cover.
DELUXE FAIRING
Fairing Removal
1. Release fairing latches.
vmr2015-147
0.4 N•m ± 0.1 N•m
(4 lbf•in ± 1 lbf•in)
Section 07 CHASSIS
Subsection 08 (OPTION PACKAGES)
vmr2015-147-006_a
vsi2012-019-017_b
2. Remove fairing brackets.
1
3
2
vsi2012-019-005_a
1. Bracket
2. Clamp
3. Bracket screw
4. Elastic stop nut
Fairing Installation
The Installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
NOTE: The bracket screw must be tighten just
enough so it can be adjusted for final assembly.
When adjusted, tighten screw to specification.
4
597