BRP Cam-am Outlander 6x6 DPS 2015 Manual page 455

PROCEDURES
PLASTIC RIVET
Plastic rivets are used in the riveting of the vari-
ous body parts. Plastic rivets can be reused many
times. Use the
OETIKER PLIERS (P/N 295 000 070)
to remove them.
V06L08A
TYPICAL
1. Pliers
2. Plastic rivet
DECALS
Decal Removal
Using a heat gun warm up one end of decal for a
few seconds until decal can roll off when rubbing
with your finger.
Pull decal slowly and when necessary apply more
heat to ease removal on the area that has to be
peeled off.
If decal tears while pulling off, it has to be heated
for a few seconds longer. If decal tends to stretch
while pulling off, stop heating and wait a few sec-
onds to let it cool, then peel it off.
Decal Installation
Using isopropyl alcohol, clean the surface and dry
thoroughly.
Apply liquid soap to new decal and carefully posi-
tion it. Using a sponge or a squeegee, remove the
air bubbles and surplus water working from the
center toward the edges. Allow to air dry.
NOTICE
Do not apply isopropyl alcohol or
solvent directly on decals. Use these products
in a well ventilated area.
vmr2015-146
2 1
Section 07 CHASSIS
Subsection 07 (BODY)
FRONT BODY MODULE
Front Body Module Removal
1. Disconnect battery negative (-) cable.
2. Remove the following panels, see procedure in
this subsection.
SIDE PANELS
–
– INNER FENDER PANELS
3. Remove front skid plate retaining screws.
vmr2012-043-001_a
1. Front skid plate retaining screws
4. On applicable models, disconnect both winch
power cables.
vmr2012-043-002_a
SOME PARTS REMOVED FOR CLARITY
1. Winch power cables
5. Disconnect headlight connectors.
.
573