Special Procedures - BRP Cam-am Outlander 6x6 DPS 2015 Manual

SPECIAL PROCEDURES

SERVICE PRODUCTS
Description
XPS LUBE......................................................................................
GENERAL
NOTE: Component failures resulting from these
events are not warrantable.
Refer to the appropriate subsections in this man-
ual for details of the required tasks as outlined in
these procedures.
WHAT TO DO IF WATER IS IN
THE CVT
The CVT drain plug is located on the rear portion
of the CVT cover. It is accessible from the rear LH
fender.
Inspect the CVT drain plug to validate if water is
present.
vmr2015-110-001_a
1. Drain plug
2. Spring clamp
NOTICE
If water is present in the CVT, it could
result in belt slippage. The engine will acceler-
ate but the vehicle will remain still.
If water is present, remove CVT drain plug to ex-
pel water.
Reinstall the drain plug and secure it using the
spring clamp.
NOTE: Make sure hose is properly inserted on
CVT cover nipple.
If an appreciable amount of water is drained from
the CVT cover, remove the cover and properly ser-
vice the CVT.
vmr2015-110
Section 01 MAINTENANCE
Subsection 07 (SPECIAL PROCEDURES)
Part Number
293 600 016 ........................................... 68
WHAT TO DO IF WATER IS IN
THE AIR FILTER HOUSING
Inspect the drain reservoir underneath the air filter
housing to validate if water is present.
vmo2012-012-054_a
TYPICAL
1. Air filter housing drain reservoir
If water is present, press clamp and remove reser-
voir to drain water from air filter housing.
If one of the following conditions is met, refer to
WHAT TO DO IF VEHICLE IS IMMERSED IN WA-
TER
:
– If more than 50 ml (2 U.S. oz) of water (approxi-
mately 5 drain reservoirs) is found in the air filter
housing.
– If any deposits are present in the drain reservoir.
NOTICE
Failure to service vehicle properly
may lead to component permanent damage.
WHAT TO DO IF VEHICLE IS
TURNED OVER
In the event the vehicle was rolled over tilted on
it's side; put the vehicle back on its wheel, wait 3
to 5 minutes, then check the following:
– Inspect air filter housing for oil accumulation,
if any oil is found, clean air filter and air filter
housing.
– Check engine oil level and refill if necessary.
– Check engine coolant level and refill if neces-
sary.
– Check gearbox oil level and refill if necessary.
Page
67