BRP Cam-am Outlander 6x6 DPS 2015 Manual page 115

2 1
A
R400motr68A
1. Rocker arm (exhaust side)
2. Roller
A. Bore for rocker arm shaft
Measure rocker arm bore diameter. If diameter
is out of specification, change the rocker arm as-
sembly.
ROCKER ARM BORE DIAMETER
NEW
SERVICE LIMIT
Check adjustment screws for free movement,
cracks and/or excessive play.
R400motr69A
1. Free movement of adjustment screw top
Rocker Arm Shaft Inspection
Check for scored friction surfaces; if so, replace
parts.
Measure rocker arm shaft diameter.
R400motr70A
A. Measure rocker arm shaft diameter here
vmr2015-117
12.036 mm to 12.050 mm
(.4739 in to .4744 in)
12.060 mm (.4748 in)
1
A
Section 02 ENGINE, CVT AND GEARBOX
Subsection 09 (TOP END (650))
ROCKER ARM SHAFT DIAMETER
NEW
SERVICE LIMIT
Any area worn excessively will require parts re-
placement.
Rocker Arm Installation
NOTE: Use the same procedure for exhaust and
intake rocker arm.
Apply engine oil on rocker arm shaft.
Insert a rocker arm shaft with the chamfered edge
first through rocker arm pin bore.
Install a thrust washer at timing chain side, then
the proper rocker arm (exhaust side or intake
side).
Push in rocker arm shaft until its chamfer reaches
the end of rocker arm bore.
vmr2006-043-016_b
1. Rocker arm shaft
2. Thrust washer (timing chain side)
3. Thrust washer (spark plug side)
Place the other thrust washer and push rocker
arm shaft to end position.
Install the camshaft retaining plate.
Adjust valve clearance, refer to
TENANCE PROCEDURE
CAMSHAFT
NOTE: The engine is equipped with two different
camshafts.
12.00 mm to 12.018 mm
(.4724 in to .4731 in)
11.990 mm (.472 in)
PERIODIC MAIN-
.
161