BRP Cam-am Outlander 6x6 DPS 2015 Manual page 38

Section 01 MAINTENANCE
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
Spark Plug Replacement
Spark Plug Access
For access to the LH spark plug, remove the aft
inner fender panel from the front LH fender.
For access to the RH spark plug, remove the RH
side panel.
Spark Plug Removal
1. Remove spark plug cable from spark plug.
2. Clean the spark plug area using pressurized air.
3. Remove spark plug.
Spark Plug Installation
Prior to installation, ensure that contact surfaces
of the cylinder head and spark plug are free of
grime.
1. Using a wire feeler gauge, set electrode gap as
TECHNICAL SPECIFICATIONS
specified in
2. Apply antiseize lubricant over the spark plug
threads to prevent possible seizure.
NOTICE
Do not apply antiseize lubricant on
the first 2 spark plug threads.
3. Hand screw spark plug into cylinder head, then
tighten to specification using a torque wrench
and an appropriate socket.
SPARK PLUG
Tightening torque
DRIVE SYSTEM
Front Differential Oil Level Verification
1. Clean filler plug prior to checking oil level.
vbl2012-007-007_a
RH SIDE OF VEHICLE
1. Filler plug
28
.
20 N•m ± 2 N•m
(15 lbf•ft ± 1 lbf•ft)
2. With vehicle on a level surface, check oil level
by removing filler plug. Oil level must reach the
lower edge.
3. Reinstall filler plug with a NEW sealing ring.
FILLER PLUG
Gasket
Tightening torque
Front Differential Oil Replacement
1. Place vehicle on a level surface. Set transmis-
sion in park position.
2. Place a drain pan under the front differential.
3. Remove drain plug.
4. Remove filler plug.
vmr2012-036-001_a
RH SIDE OF VEHICLE
1. Filler plug
2. Drain plug
5. Lift LH side of vehicle to completely drain front
differential.
NOTE: Allow enough time for oil to flow out.
6. Lower vehicle on the ground.
7. Install and tighten drain plug to specification.
DRAIN PLUG
Tightening torque
8. Refill front differential with recommended oil.
NEW
22.5 N•m ± 2.5 N•m
(17 lbf•ft ± 2 lbf•ft)
7.5 N•m ± 0.5 N•m
(66 lbf•in ± 4 lbf•in)
vmr2015-107