BRP Cam-am Outlander 6x6 DPS 2015 Manual page 239

PCODE MODULE
P0107 ECM
P0108 ECM
P0112 ECM
vmr2015
Subsection XX (DIAGNOSTIC AND FAULT CODES)
DESCRIPTION
Damaged sensor,
Manifold Air damaged circuit wires,
Pressure Sensor damaged connector or
voltage too Low damaged ECM pins, ECM
voltage supply Low
Damaged sensor, wires
Manifold Air
shorted to battery +,
Pressure Sensor
ECM voltage supply too
voltage too High
High.
Damaged sensor,
Intake Air
damaged circuit wires,
Temperature
damaged connector or
Sensor 1 circuit
damaged ECM pins, ECM
Low
voltage supply Low
CAUSE
Make sure sensor
connector is fully inserted.
Measure voltage between
harness connector pins 1 and 3
. (Expected value: 4.8 to 5.1 volts)
Measure resistance from
connector: ECM-F3 to MAPTS-2
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-A1 to MAPTS-3
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-G2 to MAPTS-1
(Expected value: < 2 ohms)
Measure resistance from connector:
ECM-F2 to MAPTS-4 (Expected
value: < 2 ohms)
Make sure sensor
connector is fully inserted.
Measure voltage between
harness connector pins 1 and 3
. (Expected value: 4.8 to 5.1 volts)
Measure resistance from
connector: ECM-F3 to MAPTS-2
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-A1 to MAPTS-3
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-G2 to MAPTS-1
(Expected value: < 2 ohms)
Measure resistance from connector:
ECM-F2 to MAPTS-4 (Expected
value: < 2 ohms)
Make sure sensor
connector is fully inserted.
Measure voltage between
harness connector pins 1 and 3
. (Expected value: 4.8 to 5.1 volts)
Measure resistance from
connector: ECM-F3 to MAPTS-2
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-A1 to MAPTS-3
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-G2 to MAPTS-1
(Expected value: < 2 ohms)
Measure resistance from connector:
ECM-F2 to MAPTS-4 (Expected
value: < 2 ohms)
ACTION
7