Table of Contents
Advertisement
Section 05 ELECTRICAL SYSTEM
Subsection 06 (DIGITALLY ENCODED SECURITY SYSTEM (D.E.S.S.))
KEY
BLACK key
GRAY key
8. Click on the appropriate Add Key button.
tbl2011-001-053_d
1. Add Performance Key button
2. Add Normal Key button
NOTE: The Add Work Key button is not used for
these vehicles.
9. Turn ignition switch to OFF.
10. Remove the key.
11. Insert the next key to be programmed.
12. Turn ignition key to ON position.
13. Click on the appropriate Add Key button.
14. Repeat to program more keys if needed.
15. Click on Write Data button to transfer new
settings and information to the ECM.
vmr2006-012-100_ben
WRITE DATA BUTTON
When new data is written in the ECM, a message
that says "Remove key from vehicle" is displayed
in the gauge. When this occurs, remove the key
from ignition switch and wait until the message
disappears.
16. Turn ignition key to ON position.
17. Erase occurred fault(s) in the fault tabs.
18. Turn ignition switch to OFF.
19. Click on EXIT button to end session.
448
KEY TYPE
Performance key
Normal key
20. Disconnect all cables and hardware from vehi-
cle.
21. Ensure to reinstall the connector into its hous-
ing.
vmr2015-136
Advertisement
Table of Contents
Troubleshooting
