BRP Cam-am Outlander 6x6 DPS 2015 Manual page 26

Section 01 MAINTENANCE
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES (650))
vmr2012-005-001_a
1. Cover position arrow
2. Locked
3. Unlocked
EXHAUST SYSTEM
Muffler Spark Arrester Cleaning and
Inspection
CAUTION Never perform this operation
immediately after the engine has been running
as exhaust system is very hot.
1. Remove and discard the tail pipe retaining
screws.
vmr2015-107-002_a
1. Screws
2. Tail pipe
2. Remove exhaust tail pipe, gasket (discard) and
spark arrester.
16
tmo2011-001-041_a
1. Spark arrester
2. Gasket
3. Exhaust tail pipe
3. Remove carbon deposits from the spark ar-
rester using a brush.
NOTICE
Use a soft brush and be careful to
avoid damaging spark arrester mesh.
tmo2011-001-043_a
1. Clean spark arrester
4. Inspect mesh of spark arrester for any damage.
Replace as required.
5. Inspect spark arrester chamber in muffler.
Clean as required.
For installation, reverse the removal procedure.
However pay attention to the following.
Install new gasket and new retaining screws.
TAIL PIPE RETAINING SCREWS
Tightening torque
11 N•m ± 1 N•m
(97 lbf•in ± 9 lbf•in)
vmr2015-107