BRP Cam-am Outlander 6x6 DPS 2015 Manual page 347

Taillight Wire Identification
FUNCTION
Supplied when main relay
R2 activated
Ground from BK2
Taillight Circuit Protection
CONDITION
Supplied when main
relay R2 activated
Taillight/Brake Light Bulb Replacement
1. Unplug connector from bulb.
2. Rotate light bulb counterclockwise to remove it
from taillight.
vmo2012-012-062_a
ROTATE BULB COUNTERCLOCKWISE
3. Remove bulb socket from taillight.
Installation is the reverse of the removal proce-
dure.
WINCH
Winch Wire Identification
WINCH RELAY
FUNCTION
12 volt input from battery
(winch power)
Ground
12 volt input from
switch (IN)
vmr2015-137
Subsection 07 (LIGHTS, GAUGE AND ACCESSORIES)
CIRCUIT
PIN
PROTECTION
3 ORANGE/GREEN
2 BLACK
CIRCUIT PROTECTION
Fuse 4 of fuse block 1
(from main relay R2)
PIN COLOR
BP4 RED
BN4 BLACK
SW1 GREEN/BLUE
Section 05 ELECTRICAL SYSTEM
WINCH RELAY
FUNCTION
12 volt input from
switch (OUT)
Motor power (switches
polarity depending on
rotation direction)
Motor power (switches
polarity depending on
rotation direction)
NOTE: The small black wire at terminal BN4 con-
nected to the diodes are used to prevent electric
arcs in the switch.
WINCH SWITCH
FUNCTION
12 volt input from fuse 7
12 volt output to relay
winding (IN)
12 volt output to relay
winding (OUT)
WARNING
Before testing, make sure the winch is in
FREESPOOL mode (Freespool clutch disen-
gaged).
tmr2011-030-003_a
SIMPLIFIED WINCH WIRING DIAGRAM
1. Winch motor
2. Winch relay
3. Winch remote control
4. Winch switch
5. Battery
6. 12 volt input to switch (switch pin 2 - from fuse 7)
7. Winch motor power (SW3)
8. Winch motor power (SW5)
9. 12 volt input to relay winding (IN - SW1)
10. 12 volt input to relay winding (OUT - SW2)
PIN COLOR
SW2 LIGHT BLUE
RED (with blue
SW3
sleeve)
RED (with
SW5
yellow sleeve)
PIN COLOR
A RED/BLACK
C GREEN/BLUE
B LIGHT BLUE
459