Ing System - BRP Cam-am Outlander 6x6 DPS 2015 Manual

Section 07 CHASSIS
Subsection 08 (OPTION PACKAGES)
tsi2012-040-105_a
1. Accessory connector
2. Visor jack harness connector
6. Remove the visor jack harness; pull it off under
the air intake hose then by the LH side of steer-
ing column.
tsi2012-040-104_a
1. Visor jack harness
2. Visor jack harness connectors
Heated Visor Installation
The installation is the reverse of the removal pro-
cedure.
HEATED HAND GRIPS AND
THROTTLE COMBO
Heating Control Module Removal
1. Remove the console. Refer to
tion.
2. Remove the handlebar cover. Refer to

ING SYSTEM

subsection.
3. Remove the gauge support. Refer to
GAUGE AND ACCESSORIES
4. Disconnect all heating control module harness
connectors (5x) located under the air intake
duct.
592
vmr2015-147-002
5. Cut all locking ties securing wires on the han-
vmr2015-147-001_c
6. Gently pull the heating control module harness
7. Remove heating control module retaining
BODY
subsec-
STEER-
LIGHTS,
subsection.
vsi2012-009-020
dlebar.
out of the console support.
screw.
vmr2015-147