Engine Oil Filter; Hcm Oil Filter (Se5 Model) - BRP Spyder RT Operator's Manual

MAINTENANCE PROCEDURES
NOTE: When the engine oil filter and
the HCM oil filter are replaced, the
total oil quantity to add will be 4.3 L
(4.5 qt (U.S. liq.)).
26. Reinstall all removed body panels.
27. Dispose of used oil as per your lo-
cal environmental regulations.

Engine Oil Filter

Engine Oil Filter Removal
ENGINE OIL CHANGE
1. Refer to
removal of the required body pan-
els.
2. Remove oil filter cover screws.
rmr2008-011-105_a
TYPICAL
1. Oil filter cover
2. Cover screws
3. Remove oil filter cover with O-ring.
Discard O-ring.
4. Remove oil filter.
5. Dispose filter as per your local envi-
ronmental regulations.
Engine Oil Filter Installation
Installation is the reverse of the re-
moval procedure. However, pay atten-
tion to the following.
1. Check and clean the oil inlet and out-
let orifices in crankcase for dirt and
contaminants.
______________
130
rmr2008-011-004_a
TYPICAL
1. Oil inlet orifice from oil pressure pump
2. Oil outlet orifice to engine lubrication system
for
2. Install a NEW O-ring on the oil filter
cover.
To ease assembly and prevent dis-
placement of the O-ring during instal-
lation, slightly oil filter and O-ring, refer
to following illustration.
rmr2008-011-005_a
1. Apply oil here

HCM Oil Filter (SE5 Model)

NOTE: The HCM (Hydraulic Control
Module) uses the same oil as the en-
gine, but has its own oil filter.
NOTICE
engine oil filter at the same time.
HCM Oil Filter Removal
1. Remove oil filter cover screws.
Replace HCM oil filter and