NEC NEAX 2000 Programming Manual page 1134

(1/2)
GENERAL DESCRIPTION
This feature allows line status of Single Line Telephones and D
NANCE ADMINISTRATION TERMINAL (MAT), for the detection of faulty lines dunning regular test-
ing or after complaints.
STATION APPLICATION
Not applicable
OPERATING PROCEDURE
Refer to the Maintenance Manual.
SERVICE CONDITIONS
l. This feature is effective during on-line status only.
2. For Single Line Telephones, this feature affect the operating status of the stations accommodated in the
same LC card as the station to be displayed. Therefore, it is recommended that this feature is per-
formed after complaints or problems should occur.
3. Printout of station line status is not available through the printer connected to the MAT.
4. Station line status is displayed in numerical data.
The numerical data represents the status from both hardware and software aspects. Following shows
the numeral data displayed and their corresponding status:
• Hardware Status
Displayed Data
00
01
02
03
04
05
06
08
Page 352
Revision 1.0
STATION LINE STATUS DISPLAY
Status (Single Line Telephone)
Terminal is not connected
Terminal is connected
Circuit is looped
OR
Short Circuit
A - wire is grounded
LC card is not mounted
Test Busy
-
-
ND-91285-001(E)
DECEMBER, 1999
term
s to be displayed on the MAINTE-
term
Status (D )
Terminal is not connected
OR
B - wire is grounded
Terminal is connected
Short Circuit
A - wire is grounded
DLC card is not mounted
Terminal Failure
DLC Card Down
Line Failure