NEC NEAX 2000 Programming Manual page 1115

SPLIT CALL FORWARDING - BUSY LINE (CONT'D)
OPERATING PROCEDURE (CONT'D)
From a Single Line Telephone and D
key:
To set SPLIT CALL FORWARDING - BUSY LINE:
1. Lift the handset; receive Dial Tone.
2. Dial the SPLIT CALL FORWARDING - BUSY LINE feature access code; receive Special
Dial Tone.
3. Dial the desired destination number (0-9); receive Service Set Tone.
DESTINATION NUMBER
0 : Target Station for SPLIT CALL FORWARDING - BUSY LINE (Block No.0)
1 :
2 :
3 :
4 :
5 :
6 :
7 : Target Station for SPLIT CALL FORWARDING - BUSY LINE (Block No.7)
8 : Target Station for CALL FORWARDING - BUSY LINE
9 : SPEED CALLING - STATION
Note: Destination No. 0-7 is pre-assigned in system programming.
4. Replace the handset.
To cancel SPLIT CALL FORWARDING - BUSY LINE:
1. Lift the handset; receive Dial Tone.
2. Dial the SPLIT CALL FORWARDING - BUSY LINE cancellation code; receive Service Set
Tone.
SERVICE CONDITIONS
1. This feature allows a station to set the two kinds of call forwarded stations. One is the target station
assigned for CALL FORWARDING - BUSY LINE, the other is the target station assigned for SPLIT
CALL FORWARDING - BUSY LINE. The target stations for SPLIT CALL FORWARDING is pre-
assigned in system programming.
2. Either CALL FORWARDING - BUSY LINE or SPLIT CALL FORWARDING - BUSY LINE can be
selected for the feature available per tenant in system programming, depending on the type of the
incoming call which is an internal call/attendant assisted call, a Tie Line call, or a C.O. call.
3. SPLIT CALL FORWARDING - BUSY LINE allows any incoming DIRECT INWARD DIALLING
(DID), DIRECT-IN TERMINATION (DIT), Tie Line, and internal calls which encounter a busy condi-
tion to be forwarded to a predetermined location (Attendant Console, another station, or voice mail
equipment).
4. SPLIT CALL FORWARDING - BUSY LINE and SPLIT CALL FORWARDING - DON'T ANSWER
must be set to the same destination to result in SPLIT CALL FORWARDING - BUSY LINE/ - DON'T
ANSWER.
term
without SPLIT CALL FORWARDING - BUSY LINE feature
ND-91285-001(E)
DECEMBER, 1999
(2/2)
(Block No.1)
(Block No.2)
(Block No.3)
(Block No.4)
(Block No.5)
(Block No.6)
Page 333
Revision 1.0