Descriptions Of The Plc Subroutines; Plc Machine Data - Siemens SINUMERIK 808D Operating Instructions Manual

Descriptions of the PLC subroutines

3.1

PLC machine data

Table 3- 1
No.
14510 [12]
14510 [13]
14510 [20]
14510 [21]
14510 [22]
14510 [24]
14510 [25]
Table 3- 2
No.
14512 [16]
14512 [17]
14512 [18]
14512 [19]
PLC Subroutines Manual
Operating Instructions, 12/2012, 6FC5397-2EP10-0BA0
USER_DATA_INT
Unit Description
- Layout of the traverse keys
0.1s Time for spindle braking
- The maximum number of tool bits
0.1s Turret clamping time
0.1s Monitoring time for searching a tool
1 min Lubricating intervals
0.01s Lubricating duration
USER_DATA_HEX
Descriptions
Bit 1: function of chip remover (milling)
Bit 2: function of safe door (milling)
Bit 3: when the function of safe door is active, it can be triggered by M01/M02
(milling).
Bit 4: control of X axis rotation monitoring
Bit 5: control of Y axis rotation monitoring
Bit 6: control of Z axis rotation monitoring
Bit 7: handwheel assignment with the MCP / HMI
Bit 0: turret (turning); tool magazine (milling)
Bit 1: clamping function (turning)
Bit 2: tail stock function (turning)
Bit 3: selection between handwheel and hand-held unit (0: handwheel; 1: hand-held
unit)
Special configurations for a machine
Bit 2: automatic lubrication after first power-on (factory setting)
Bit 4: signal that external spindle stops
Bit 5: spindle positioning direction
Bit 6: the hardware limit is independent from a PLC program
Bit 7: each feed axis has a hardware limit switch (activated when Bit 6 = 0)
Bit 1: function of spindle braking
Bit 2: password clearing by power-on (0: delete the password; 1: do not delete the
password)
Bit 7: manual machine function (this function become active if you have installed
licensed turning machine system and called it with a PLC subroutine)
3
31