Mitel SX-200 Practices page 1151

14
' DATASET 1100 SERIES
DESCRIPTION
14.1 The DATASET 1100 series asynchronous datasets are composed of four variants; a
DATASET 1101 Cartridge, a DATASET II 02 Dual Rack Mounted card, a Standalone
DATASET 1103 unit, and a
MjLhk
Data Module (DSIIOI M). The DATASET 1100
series support asynchronous data communications at rates up to 19.2 kilobits per
second. The DATASET I 101, DATASET 1102, and DATASET I 103 interface with an
\
SX-200 DIGITAL PABX through a DNI Line Card within the PABX. The
MiLink
Data
Module interfaces with an SX-200 FD (Fiber Distributed) PABX via the
MiLink
Bus
(only available with Generic 1005).
These datasets (except the
MiLink
Data Module) operate with the MITEL Digital
Network Interface Circuit (DNIC) digital link technology which is composed of three
channels: a 64 kbps voice or data (B) channel, a 64 kbps data (B) channel, and a 16
kbps (D) channel for control communications between the set and the PABX.
The DATASET II 01 Cartridges and Standalone DATASET II 03 interface peripheral
devices to the PABX, while the DATASET 1102 Dual Rack Mounted cards usually
interface a host computer to the PABX.
The
MiLink
Data Module is packaged in a flat case like the DATASET 1103 and is
designed to fit under the
SUPERSET 410, SUPERSET
420, and
SUPERSET 430
telephones. It interfaces peripheral devices to the PABXvia the
SUPERSET
series
telephone sets.
Data terminal equipment (DTE) or data communications equipment (DCE) mode is
selected by the use of a Modem Adapter plugged into W-232 (EA1232) interface of
the DATASET 1102, DATASET 1103, and
M/Link
Data Module.
Baud Rates
=l4.2 The DATASET II 00 series operate at the following baud rates:
110 - 150 - 200
- 300 - 600 - 1200 - 2400 - 4800 - 9600 - 19200
Connector Pin Assignment Tables
14.3 The W-232 connectors used on the DATASET 1100 series have the following pin
assignments when operating in Data Communications Equipment (DCE) mode:
9109-09&126-NA Issue1
Revision
0
126 14-l