Toyota Tundra 2005 Service - Repair - Maintenance page 1811

EM−108
Cylinder Block Side
Main Bearing Cap Side
A04850
A04210
A04212
ENGINE MECHANICAL (2UZ−FE)
INSPECTION
1.
(a)
(b)
A04849
2.
(a)
If warpage is greater than maximum, replace the cylinder block.
A05178
(b)
If deep scratches are present, rebore all the 8 cylinders and re-
place all the 8 pistons. (See page EM−115) If necessary, re-
place the cylinder block.
A04853
− CYLINDER BLOCK
CLEAN CYLINDER BLOCK
Using a gasket scraper, remove all the gasket material
from the top surface of the cylinder block.
Using a soft brush and solvent, thoroughly clean the cylin-
der block.
INSPECT CYLINDER BLOCK
Inspect for flatness.
Using a precision straight edge and feeler gauge, mea-
sure the surfaces contacting the cylinder head and main
bearing cap for warpage.
Maximum warpage: 0.07 mm (0.0028 in.)
Visually check the cylinder for vertical scratches.
EM0EB−20