Rep 12.22 Eject/Set Clamp Motor Assembly - Xerox VersaLink B7025 Service Manual

4. Remove the eject belt, Figure 2:
a. Move the blades of the set clamp shaft (1) in the direction of the arrow.
b. Remove the eject belt (2) in the direction of the arrow.
Figure 2 Eject belt removal
Replacement
1. The replacement is the reverse of the removal procedure.
2. Ensure the eject belt is aligned with the marks on the pulleys,
Figure 3 Eject belt installation
Repairs and Adjustments
REP 12.21, REP 12.22

REP 12.22 Eject/Set Clamp Motor Assembly

Parts List on
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the integrated office finisher,
2. Remove the front inner cover,
3. Remove the rear cover,
4. Turn over the integrated office finisher.
5. Remove the bottom cover,
6. Remove the connector bracket,
a.
b.
c.
d.
Figure 3.
7. Remove the bottom plate,
a.
b.
c.
d.
e.
April 2017
4-84
PL 12.25
WARNING
REP 12.1.
PL 12.05 Item
PL 12.05 Item 14.
PL 12.06 Item 1.
Figure 1:
Release the harness from the three clamps (1).
Disconnect five connectors (2).
Remove two screws (3).
Remove the connector bracket (4).
Figure 1 Connector bracket removal
Figure 2:
Release the harness from the five clamps (1).
Disconnect eight connectors (2).
Release the harness from the retainer (3).
Remove four screws (4).
Remove the bottom plate (5).
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
GP 10. Disconnect the power cord
6.
Launch Issue