Rep 2.1.2: Eject Roller Assembly - Xerox 450c Service Manual

REP 2.1.2: Eject Roller
Assembly
Parts List: 2.1
1. Perform the following:
a. REP 1.1: WorkCentre Cover on page 4-3
b. REP 2.1.1: Exit Guide on page 4-4.
2. Remove the two screws that hold the eject
roller assembly to the printer, and remove the
assembly.
3. At each end of the eject roller there is a roller
shaft securing cam (Figure 4-1). Pry the end
out slightly (by the red dot on the cam tab
and rotate until the tab points down.
Eject roller
Rotate cam
Figure 4-1 Eject roller assembly
4. Lift the roller out of the roller guide.
Xerox WorkCentre 450c/450cp Service Manual
NOTE: After you replace the eject roller assembly,
you must perform ADJ 2.2: Printhead Gap Adjustment on page 4-46
and ADJ 2.1: Printhead Alignment on page 4-45.
www.printcopy.info
Page 4-5