Removing The Eject Belts (J0Fa42280); Rep 22.9.4 Eject/Set Clamp Motor Assembly - Xerox WorkCentre 5222 Service Manual

5. Remove the Eject Belts. (Figure 2)
(1)Move the blades of Set Clamp Shaft in the direction of the arrow.
(2)Remove Eject Belts in the direction of the arrow.
Figure 2 Removing the Eject Belts (j0fa42280)
Replacement
1. Reverse the removal procedure for replacement.
2. Install and align the Eject Belts with marks on the Pulleys.
Figure 3 Installing the Eject Belts (j0fa42278)
Launch Version
WorkCentre 5225, 5230

REP 22.9.4 Eject/Set Clamp Motor Assembly

Parts List on
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1.
2.
3.
4.
5.
6.
(Figure 3)
February, 2008
4-209
PL 22.9
WARNING
Remove the A-Finisher from the machine.
Remove the Inner Front Cover. (PL 22.1)
Remove the Rear Cover. (PL 22.1)
Turn over the A-Finisher.
Remove the Bottom Cover. (PL 22.2)
Remove the Connector Bracket. (Figure
(1)Release Clamps (3) and remove the wires.
(2)Disconnect Connectors (5).
(3)Remove Screws (2).
(4)Remove Connector Bracket.
Figure 1 Removing the Connector Bracket (j0fa42266)
(REP 22.1)
1)
Repairs and Adjustments
REP 22.9.3, REP 22.9.4