Agilent Technologies E5071C Manual page 1163

Hide thumbs Also See for E5071C:

Table of Contents

For channel 1, turn on the continuous trigger startup mode to On and set

the trigger source to the bus trigger.

Lines 320 to 360

For channel 1, set the sweep center value to the Center variable, the

sweep span value to the Span variable, the number of measurement points

to the Nop variable, the IF bandwidth to the IfBw variable, and the power

level to the Pow variable.

Lines 380 to 410

For channel 1, set the number of traces to the NumTrac variable, the

measurement parameter to the Par variable, and the data format to the

Fmt variable.

Stores the calibration kit number for channel 1 into the CalKit variable.

Stores 1 and 2 into the Port variable that indicates ports used for the full

2-port calibration.

Calls the Calib_Solt procedure (lines 1200 to 2130).

Lines 520 to 530

Save the instrument setting and the calibration coefficient into a file whose

name is specified with the File variable.

Displays a message that prompts you to connect a DUT (Device Under

Test) in the instrument status bar in the lower part of the LCD display and

waits for the operation of

> Continue after the connection.

Lines 620 to 630

Generate a trigger to start a single sweep and wait until the measurement

finishes (1 is read out with the SCPI.IEEE4882.OPC object).

For trace 1 of channel 1, executes auto scale to set the optimum scale.

Lines 690 to 710

Display marker 1 and move it so that the stimulus value becomes equal to

the value of the Center variable. Then, these lines read out the response

value of marker 1 and store it into the MkrVal variable.

Show Quick Links

Table of Contents