Agilent Technologies E5071C Manual page 1177

E5071C
Calls the Display_Update procedure (lines 3280 to 3620). For information
on the Display_Update procedure, see the description later.
Line 810
Displays the user form (object name: frmDupRes) on the screen to display
the analysis result.
Lines 830 to 870
Display the message asking whether you want to perform measurement
again. Click the Yes button to return to the DUT connection section. Click
the No button to terminate the program.
Procedure: Setup_Parameter (lines 910 to 1140)
Lines 970 to 1020
Store the channel layout ("D1": 1-channel display), graph layout ("D1_2":
upper/lower 2 part split display), measurement parameter of trace 1
(S13), measurement parameter of trace 2 (S21), data format of trace 1
(MLOG), and data format of trace 2 (MLOG) into the ChDisp, TracDisp,
Par(0), Par(1), Fmt(0), and Fmt(1) variables, respectively.
Lines 1040 to 1060
Set the number of traces for channel 1 to 2, the channel layout to the
ChDisp variable, and the graph layout for channel 1 to the TracDisp
variable.
Lines 1080 to 1120
Set the measurement parameter for trace 1 to the Par(0) variable, the
data format for trace 1 to the Fmt(0) variable, the measurement
parameter for trace 2 to the Par(1) variable, and the data format for trace
2 to the Fmt(1) variable.
Procedure: Setup_Segment (lines 1160 to 1530)
Lines 1200 to 1260
Store the conditions for channel 1's segment table setting into the
SegmData(0) to SegmData(6) variables. The settings are as follows.
Stimulus setting mode: start/stop value. IF bandwidth setting for each
segment: off. Power setting for each segment: off. Sweep delay time
setting for each segment: off. Sweep time setting for each segment: off.
Number of segments: 5.
Lines 1280 to 1470
Store the sweep start value, the sweep stop value, and the number of
measurement points for channel 1's segments 1 through 5 into the
SegmData(7) to SegmData(21) variables, respectively.
1404