Agilent Technologies E5071C Manual page 1176

Hide thumbs Also See for E5071C:

Table of Contents

Lines 450 to 460

For traces 1 and 2, these lines executes the auto scale to set the optimum

Lines 490 to 500

Read out the value of the questionable limit status event register and store

the AND of the read-out value and 2 (the value in which only bit 1 is 1)

into the Test_Ch1 variable.

Lines 510 to 530

Read out the value of the questionable limit channel 1 status event register

and store the AND of the read-out value and 2 (the value in which only bit

1 is 1) into the Test_Tr1 variable and the AND of the read-out value and 4

(the value in which only bit 2 is 1) into the Test_Tr2 variable.

Lines 560 to 610

Specify trace 1 as the active trace and set the analysis range (start point:

1.85 GHz and stop point: 1.91 GHz). Then these lines sets the polarity of

the peak search (both the positive peak and the negative peak) and the

lower limit of the peak excursion value (0).

Lines 620 to 640

Search for the minimum value within the analysis range and store the

analysis result into the IlossTx variables.

Uses the ripple analysis function to store the maximum value of the

response differences between the positive peaks and the negative peaks

within the analysis range into the RipTx variables.

Lines 670 to 720

Specify trace 2 as the active trace and set the analysis range (start point:

1.93 GHz and stop point: 1.99 GHz). Then these lines set the polarity of

the peak search (both the positive peak and the negative peak) and the

lower limit of the peak excursion value (0).

Lines 730 to 750

Search for the minimum value within the analysis range and store the

analysis result into the IlossRx variables.

Uses the ripple analysis function to store the maximum value of the

response differences between the positive peaks and the negative peaks

within the analysis range into the RipRx variables.

Show Quick Links

Table of Contents