Dhcp Mode - Dell S6000 Reference Manual

CONTROL-PLANE Mode
To manage control-plane traffic, use CONTROL-PLANE mode. For more information, refer to
Plane Policing (CoPP).
To enter CONTROL-PLANE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the control-plane-cpuqos command. The prompt changes to include (conf-control-
cpuqos).
You can return to CONFIGURATION mode by using the exit command.

DHCP Mode

To enable and configure Dynamic Host Configuration Protocol (DHCP), use DHCP mode. For more
information, refer to Dynamic Host Configuration Protocol
To enter DHCP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip dhcp server command. The prompt changes to include (config-dhcp).
You can return to CONFIGURATION mode by using the exit command.
DHCP POOL Mode
To create an address pool, use DHCP POOL mode. For more information, refer to
Configuration Protocol
To enter DHCP POOL mode:
1. Verify that you are logged in to DHCP mode.
2. Enter the pool command then the pool name. The prompt changes to include (config-dhcp-pool-
name).
You can return to DHCP mode by using the exit command.
ECMP GROUP Mode
To enable or configure traffic distribution monitoring on an ECMP link bundle, use ECMP GROUP mode.
For more information, refer to ecmp_overview.
To enter ECMP GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ecmp-group command then enter the ECMP group ID. The prompt changes to include
(conf-ecmp-group-ecmp-group-id).
You can return to CONFIGURATION mode by using the exit command.
EIS Mode
To enable or configure Egress Interface Selection (EIS), use EIS mode.
To enter EIS mode:
46
(DHCP).
(DHCP).
Dynamic Host
Control
CLI Basics