Dell S6000 Reference Manual page 178

host ip-address
Defaults Not configured.
Command CONFIGURATION-STANDARD-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.1.0
Usage
The order option is relevant in the context of the Policy QoS feature only. For
Information
more information, refer to the Quality of Service chapter of the Dell Networking OS
Configuration Guide.
The software cannot count both packets and bytes, so when you enter the count
byte options, only bytes are incremented.
178
• dscp — Enter the keyword dcsp followed by the DCSP
value to match to the IP DCSCP values. The range is from
0 to 63.
• fragments — Enter the keyword fragments to use
ACLs to control packet fragments.
• order — Enter the keyword order to specify the QoS
order of priority for the ACL entry. The range is from 0 to
254 (0 is the highest priority and 254 is the lowest; lower-
order numbers have a higher priority). The default is, if
you do not use the keyword order, the ACLs have the
lowest order by default (255).
Enter the keyword host and then enter the IP address to
specify a host IP address only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Add the DSCP value for ACL matching.
Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the non-contiguous mask and added the
monitor option.
Expanded to include the optional QoS order priority for the
ACL entry.
Access Control Lists (ACL)