Dell S6000 Reference Manual page 140

Parameters
host
ip-address
ipv6-address
prefix-length
vrf instance
source-
interface
Defaults Not configured.
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
140
Enter the name of a server.
Enter the IPv4 address in dotted decimal format of the
server.
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
(Optional) Enter the keyword vrf then the VRF instance
name.
(OPTIONAL) Enter the keywords /source-interface then
the interface information to include the source interface.
Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from zero (0) to 16383.
• For the Null interface, enter the keyword null then 0.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 128.
• For Tunnel interface types, enter the keyword tunnel
then the slot/ port information. The range is from 1 to
16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Control and Monitoring