Ip Tftp Vrf - Dell S6000 Reference Manual

Version 8.5.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series
Related telnet
Commands

ip tftp vrf

Configures an TFTP client with a VRF that is used to connect to the TFTP server.
Syntax
ip tftp [vrf vrf-name]
To undo the TFTP client configuration, use the no ip tftp [vrf vrf-name]
command.
Parameters
vrf vrf-name
Defaults Disabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.4.
(0.0)
Usage Use this command to make the TFTP clients VRF aware. The VRF name that you
Information specify is used by the TFTP client to reach the TFTP server. If no VRF is specified,
then the default VRF is used.
Related
ftp-server topdir
Commands
the E-Series.
Control and Monitoring
Added support for 4-port 40G line cards on ExaScale.
Increased number of VLANs on ExaScale to 4094 (was 2094).
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command
— telnet to another device.
Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TFTP client.
Introduced on the S-Series and Z-Series.
— sets the directory to be used for incoming FTP connections to
103