Dell S6000 Reference Manual page 193

any
host ip-address
dscp
operator
port port
destination
mask
count
byte
order
fragments
Defaults Not configured.
Command CONFIGURATION-EXTENDED-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Access Control Lists (ACL)
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter this keyword dscp to deny a packet based on the
DSCP value. The range is from 0 to 63.
(OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for the port command)
Enter the application layer port number. Enter two port
numbers if using the range logical operand. The range is
from 0 to 65535.
Enter the IP address of the network or host to which the
packets are sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority) If you did not use the
keyword order, the ACLs have the lowest order by default
(255).
Enter the keyword fragments to use ACLs to control packet
fragments.
193