Dell S6000 Reference Manual page 197

destination
count
bytes
dscp
order
fragments
Defaults Not configured.
Command CONFIGURATION-EXTENDED-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.10
Access Control Lists (ACL)
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword bytes to count bytes
processed by the filter.
(OPTIONAL) Enter the keyword dcsp to match to the IP
DCSCP values.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
Enter the keyword fragments to use ACLs to control packet
fragments.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Add the DSCP value for ACL matching.
Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the non-contiguous mask and added the
monitor option.
Expanded to include the optional QoS order priority for the
ACL entry.
197