Ethernet Link Ports Or Lom Not Coming Up On Reboot In Linux; Loss Of Adapter Hardware Address In Linux; Loss Of Adapter Ip Address In Linux - Dell Brocade Adapters Troubleshooting Manual

Ethernet link ports or LOM not coming up on reboot in Linux

The host system's LAN on motherboard (LOM) is not coming up or ports are not visible after
rebooting Linux host.
1. Possible Cause: A ifcfg-ethX script is not configured to bring up each LOM and CNA during the
2. Possible Cause: NetworkManager is enabled. There are known issues with NetworkManager

Loss of adapter hardware address in Linux

The ifconfig command displays, HW Addr as 00:00:00:00:00:00.
Possible Cause: The adapter failed to initialize.
Action: Disable the Ethernet I/O controller by entering the BCU vnic --disable command, then
enable the I/O controller by entering the BCU vnic --enable command.

Loss of adapter IP address in Linux

The IP address set in Linux with the ifconfig command disappears when the adapter goes down or
host system reboots.
1. Possible Cause: The IP address was set with the ifconfig command and the adapter is enabled
Brocade Adapters Troubleshooting Guide
53-1002145-01
system boot process.
Action: Make sure that a script is configured for each adapter and LOM once drivers are
installed. Scripts are located in the following directories:
•
SLES - /etc/sysconfig/network
•
RHEL - /etc/sysconfig/network-scripts
managing multiple NICs in some Linux distributions.
Action: Disable NetworkManager.
To check if NetworkManager is running, enter either of the following commands:
•
chkconfig --list | grep NetworkManager
•
nm-tool
To disable NetworkManager for RHEL 5 systems, enter the following commands.
chkconfig NetworkManager off
chkconfig NetworkManagerDispatcher off
To disable NetworkManager for SLES systems, perform the following steps.
a. Open YaST.
b. Select the Network Devices Network Card.
c. On the first screen set the Network Setup Method option to Traditional Method with ifup.
in DHCP (Dynamic Hardware Configuration Protocol) mode.
Action: Configure IP address using system GUI-based networking tools.
Network interface problems (CNA or NIC)
2
33